• FREE SHIPPING applied to orders over $100
  • *Discreetly* delivering Australia Wide
  • Sign up to our newsletter for 10% off*
  • FREE SHIPPING applied to orders over $100
  • *Discreetly* delivering Australia Wide
  • Sign up to our newsletter for 10% off*

New Blogs every friday

Stoners Guide: How To Roll A Cross Joint

Stoners Guide: How To Roll A Cross Joint

Ahhh the cross-joint... a quintessential for the stoner. Are you even a stoner if you haven’t had a cross joint?? Today I’m gonna show you how to EASILY make one. They might seem daunting but trust me, todays tutorial is gonna be a quick one. 

 

Materials:

Herb

1x King Size Paper

3x Single Wide Papers

1x Curved tip (you can use a straight tip if you don’t have a curved tip)

A Needle

A Skewer

A Chopstick

 

Step 1 

Roll your king sized joint with the curved tip and twist the top closed (to see how I roll my coned joints click this link).

 

Step 2

Roll your single wide joint (no tip/filter) leave a little room either side of the joint to twist off each side.

Step 3

Stab your needle through the top third of your king sized joint, work the needle around in circles until its big enough to then fit the skewer through.

Push the skewer through the hole and work it around in circles until its big enough to then fit the chop stick through.

Push the chopstick through the hole and work it around in circles until its big enough to then fit the single wide joint through.

 

Step 4

Before you put the single wide joint in the king size joint, you need to stab a hole through the single wide joint right down the middle, all the way through (I used the skewer to make the hole). This is a very important step so that your cross joint functions properly and smokes evenly.

Step 5

When sliding the single wide joint through, make sure the holes are facing up and down as opposed to in front and back (drawing for reference).

 

Step 6

Once your single wide joint is inside your king size joint, there is only one more thing to do! Grab your left over single wide papers and cut just the glue lines off. Take one glue strip and wet it, lay it over the weak points of the cross joint in a loop around, diagonally. Do the same on the other side diagonally in a loop (photo for reference).

Done!!

Told you it was fast. When it comes to lighting this joint, ideally, you need two people and three lighters. You on the end and your mate on the two sides. 

 

If you make a cross joint after reading this tutorial I would love if you sent it in to our insta @smokemilkau

Peace, Milo.

X

 

All blog posts are for entertainment purposes only, Smoke Milk does not condone or endorse the use of illicit or controlled substances. 
All products displayed and sold via Smoke Milk are sold with the intent for legal smoking herbs only and we encourage you to check your local laws and regulations before proceeding with a purchase.
To read more on please see our T&Cs


Write a comment

Please note, comments must be approved before they are published

Comment are moderated